Super Film Strength
High-performance
two-cycle motors
have high
compression ratios,
which significantly
increase combustion
chamber heat and
crankshaft bearing
pressures. Hot
combustion processes
quickly burn off and
evaporate light oils
and cause rapid
piston expansion,
decreasing
piston-to-cylinder
wall clearances.
This promotes piston
scuffing and
possible seizure,
and increased
pressure on
crankshaft bearings
promotes
metal-to-metal
contact, wear and
pitting.
High
heat and pressures
require tough oil
with better film
strength and more
lubricity.
DOMINATOR,
constructed with
AMSOIL heavy
synthetic oil,
handles high heat
better than mineral
oils and provides
improved film
strength and
lubricity. DOMINATOR
reduces friction and
provides an extra
measure of
protection against
piston scuffing and
crankshaft bearing
wear.
Clean Burning
High combustion
processes require
the proper additives
and oils to control
deposits. DOMINATOR
contains strong,
high-temperature
detergent additives
and highly pure
AMSOIL synthetic
oil. It helps
prevent deposits
that cause ring
sticking, plug
fouling and exhaust
port blocking.
DOMINATOR is an
optimized product
for severe service.
Applications (see
Two-Cycle
Recommendations Chart)
DOMINATOR is
recommended for use
in high performance
stock or modified
two-cycle motors,
including air or
liquid cooled
snowmobiles,
personal watercraft,
motorcycles (Moto
X), ATVs, go-carts
and outboard
motors*. Good for
use with coated or
non-coated pistons,
high-octane racing
fuels and exhaust
power valves.
Compatible with most
other two-cycle
oils, however,
mixing oils should
be minimized.
Use at 50:1 pre-mix
ratios (2.6 oz. oil
per U.S. gallon of
gas) or as injection
oil where JASO FC or
API TC oils are
specified. Not
suitable for use
with alcohol or
nitro-methane fuels.
*
Not suitable for
long-term use in
outboard motors as a
TC-W3 type oil,
although excellent
as a race oil for
short-term use where
motors are
periodically
inspected.
|
TYPICAL
TECHNICAL
PROPERTIES
DOMINATOR™
Synthetic
2-Cycle
Racing Oil
|
|
Kinematic
Viscosity @
100°C, cSt (ASTM
D-445) |
7.7 |
|
Kinematic
Viscosity @
40°C, cSt (ASTM
D-445) |
41.4 |
|
Viscosity
Index (ASTM
D-2270)
|
157 |
|
Pour Point °C
(°F) (ASTM D 97) |
-46 (-51) |
|
Flash Point °C
(°F) (ASTM D 92)
|
92 (198) |
|
Fire Point
°C (°F)
(ASTM D 92)
|
92 (198) |
|
DANGER:
harmful or
fatal if
swallowed.
Contains
synthetic
lubricant
and
petroleum
distillates.
If swallowed
do not
induce
vomiting.
Contact a
physician
immediately.
Keep away
from fire,
heat and
open flame.
Use with
adequate
ventilation.
Avoid
frequent or
prolonged
skin
contact.
Flush eyes
with water
for 15
minutes in
case of
contact.
KEEP OUT
OF REACH OF
CHILDREN.
|
